1.28-inch 240x240 tft display，Circular display
1.28 Circular display, SPI interface, IPS display mode, mainly applied to the smart wear market
Main parameters of 1.28-inch circular display
| ITEM | Standard value | UNIT |
| Display SIZE | 1.28 | INCH |
| Display Type | a-Si | — |
| Driver Element | Active Matrix | — |
| Number of Dots | 240*240 | Dots |
| Display Color | 16.7M | — |
| Pixel Pitch (W*H) | 0.135*0.135 | mm |
| Active Area | Ø32.4 | mm |
| Viewing Direction | all direction | — |
| Control IC | GC9A01 | — |
| Module Size(W*H*T) | 35.6(H) x 38.1(V) x1.5 (D) | mm |
Download relevant technical documents
GC9A01 data sheet for small lcd display
Specification of 1.28-inch small lcd display
Circuit diagram for 1.28-inch small lcd display
initial code for 1.28-inch small lcd display
Customize the length, width and thickness of FPC or cable, adjust the pin arrangement according to the interface type, and select the appropriate connector. Make your display or circuit board simple and safe with an excellent FPC solution.
A touch screen can be added according to your requirements, there are three options: resistive touch screen, capacitive touch screen, infrared touch screen. Or add protective glass as needed
Display screens with different optical parameters can be designed according to needs, such as brightness, color gamut, response time, gamma and other parameters, and anti-glare, anti-fingerprint coatings, etc. can also be added
The circuit board we designed can convert the interface of your display into an HDMI interface. If your product does not have any display control capabilities, you can use our serial display and only need to use simple commands to control the displayed content through RS232/458
1.28-inch tft display drawings and interfaces
1.28-inch IPS mode circular LCD display, resolution 240×240, driver IC GC9A01, 4-line SPI interface, backlight using 2 LED lights in parallel, working voltage: 3V, working current: 40mA, the module brightness is 400cd/㎡, the product conforms to Rohs standard, FPC and your motherboard is linked by welding, can be changed to other connection according to your needs, such as ZIF or BTB.
The outline drawing is as follows:
Interfaces are defined as follows：
| Pin | Symbol | Detail |
| 1 | GND | |
| 2 | LEDK | backlight unit power supply |
| 3 | LEDA | SPI interface input/output pin.the data is latched on the rising edge of the SCL signal. |
| 4 | VDD | This is a voltage supply pin. It must be connected to external source |
| 5 | GND | |
| 6 | GND | |
| 7 | DC | Display data/command selection pin in 4-line serial interface. |
| 8 | CS | Chip selection pin;Low enable,high disable. |
| 9 | SCL | This pin is used to be serial interface clock |
| 10 | SDA | This pin is used to be serial interface clock |
| 11 | RES | This signal will reset the device and it must be applied to properly initialize the chip.Signal is active low. |
| 12 | GND |
1.28 -inch 240 x240 tft display application cases
1.28-inch IPS display, 230×240 resolution,SPI interface, circular display area is suitable for circular knob, through rotating the screen can display the corresponding content, increase customer interaction experience, improve your device’s advanced sense.
With a 1.28-inch circular display, IPS display mode, full viewing Angle, 230×240 resolution and SPI interface, this product was originally designed to make smartwatches. This product is also a good fit for the requirements of smart wearable products, and has a very large shipment worldwide.
